Jet Ski Hull Parts & Accessories
|
|||||
   Universal Tie Down Loop $3.95ea |
Tie Down Loop
Stainless Steel. Small hole is 9.9mm (fits most M10 bolts that actually measure 9.85 OD) Large hole is 19.4mm |
||||
Blowsion Jet Ski Handlepole Extension Limiting Rope $59.95 |
Jet Ski Handlepole Extension Limiting Rope The design of the Blowsion pole limiting rope is to STOP your pole from extending approx 2-3" from total max extension. This prevents the forward motion of the pole and riders body from destroying expensive handlepoles, pole brackets, hulls and also expensive human body parts! A spring back retention cord attaches to the bottom of the pole spring area and will also pull the pole back down if you become separated from your ski in surf or large lake waves. All stainless mounting hardware and instructions included. Fits all stand up Yamaha FX1, all years Yamaha Super Jet, Polaris Octane, Kawasaki SXR 800, 750 SX, and 650 SX. A must for ocean or big wave riders. |
||||
Krash Hood Latch $54.95-$64.95ea |
Krash Hood Latch Sold each These OEM flush mount hood pin kits are lightweight, high strength, glass-reinforced thermoplastic housings that contain a hinged, spring-loaded stainless steel pin. The stainless steel pin engages with the included hood pin for a secure fit. Hardware included. |
||||
|
Aftermarket Hood Seal Heavy-duty replacement Hood Seal Fits all years Yamaha Super Jet, Yamaha FX-1, all years Polaris Octane, Yamaha Wave Blaster and most aftermarket hulls like Krash and Rickter. Includes 3M� self adhesive backing for easy installation. There is 10" of extra material on a '21+ Krash Footrocket. |
||||
Read the notes to the right. |
Scupper Valve Fits Krash hulls where the drain exits the rear This may or may not work for those that exit in the pump area. We have not tested it there. To install, remove the three small allen screws at the top of the drain cover, Cut away the adhesive in the crack with a razor blade then heat up and pry out with a tire iron. Some take a lot of force to break the sealant lose. This scupper will not work on the Krash 2021 1200s with the 4 bolt scupper cover. We are working on one for the '21s |
||||
 Hydro Turf or Jettrim Handle Pole Pad $20-30 |
Hydro Turf Handle Pole Pad A slot will need to be cut for the hood strap. Hydro-Turf Mounting Blocks can be used for a variety of applications including: handle pole pads / lifters, footholds and mounting exhausts. Blocks are 4.7″ x 5.1″. Comes with 3M self-adhesive. Available in 2" or 4" PSA = Peel and Stick Adhesive |
||||
 Rickter RRP Ninja Foot Holds $399 a pair |
Rickter RRP Ninja Foot Holds If you drill one hole these will bolt bolt right up to the Krash foothold mounts. RRP AB Ninja Binding Fiberglass 3.0 lbs (sold in pairs) No Hardware Included |
||||
 Rickter RRP Ninja Angled Foothold Wedges $279 a pair |
Rickter RRP Ninja Angled Foot Hold wedges RRP Rickter Angled Feet Support. Fits Rickter XFS Ninja Competition 2021 and Newer Models. |
||||
